IIS的SMTP和Imail装在同一台win2000服务器上

woodsonlin

在试用ORF是发现，在win2000服务器上，Imail的SMTP服务和IIS的SMTP服务无法同时启用，总是一个启动了另一个就无法启动，这样就无法实现ORF和Imail装在同一服务器上，请教各路大大，你们是怎样解决这个问题的

atong999888

imail的版本必须大于8.2
在服务器分配2个IP, 一个给IIS smtp用，一个给imail用.


配置列子:
在服务器配置2个IP, 主IP为2.2.2.1，给Imail使用, 第2个IP为2.2.2.2，给IIS的SMTP使用.
其它配置与上面的一样.


配置windows使用2个IP，如下图
按照上图配置好网络再安装imail, 在imail的TCP/IP Address自动使用IP: 2.2.2.1,

在SMTP的Advanced里禁用"Smtp to listen On All IPs"，另一个IP 2.2.2.2可留给IIS的SMTP.

配置IIS SMTP虚拟服务器的IP只使用2.2.2.2，配置如下图:


[ 本帖最后由 atong999888 于 2007-12-13 19:10 编辑 ]

woodsonlin

版主大大，我的imail是2006版的。看你的贴图，你用的操作系统好像是win2003，我试过，2003上IIS的SMTP和Imail的SMTP是可以并存的。但我现在的服务器的操作系统是2000，好像是不行的。

钉子

主要是让IIS的SMTP和Imail的SMTP使用不同的IP占用25端口。

atong999888

win2000就要多做一下面操作, win2003不需要.

HOW TO: Disable IIS 5.0 SMTP Service Socket Pooling in Windows 2000
适用于
This article was previously published under Q310155
IN THIS TASK
SUMMARY

How to Disable SMTP Service Socket Pooling
Troubleshooting
SUMMARY
This step-by-step article describes how to disable the Internet Information Services (IIS) 5.0 Simple Mail Transfer Protocol (SMTP) Service socket pooling functionality.

You can use the socket pooling functionality in IIS 5.0 to host multiple sites that use a different Internet Protocol (IP) addresses but the same port number. If you use socket pooling, you can reduce the amount of resources that the IIS 5.0 services consume. IIS 5.0 can host many more sites than IIS 4.0 because of socket pooling.

If you use socket pooling, IIS 5.0 services listen on all IP addresses regardless of the IP address that you configure in the IIS snap-in.

back to the top
How to Disable SMTP Service Socket Pooling
Use the Mdutil.exe utility that is located on the Windows 2000 CD-ROM distribution media to disable SMTP Service socket pooling:
Copy the Mdutil.ex_ file from the I386 folder on the Windows 2000 CD-ROM to the InetPub\Adminscripts folder on your local hard disk.
Open a command prompt, change the location to the folder in which you copied the Mdutil.ex_ file, and then type the following command:
expand mdutil.ex_ mdutil.exe

Type the following command at the command prompt, and then press ENTER:
mdutil.exe enum -path:smtpsvc

Type the following command at the command prompt, where number is the SMTP Service number for which you want to disable socket pooling, and then press ENTER:
mdutil set -path smtpsvc/number -value 1 -dtype 1 -prop 1029 -attrib 1

NOTES:
Run this command for each virtual server with a different value for number if you have multiple SMTP virtual servers.
When you type the command, do not include a space between "smtpsvc/" and "number".
In the IIS snap-in, change the listening address for SMTP Service to an internal interface on the server.
After you disable socket pooling and change the SMTP Service listening address, you can use Server Publishing rules to publish an internal SMTP server.

back to the top
Troubleshooting
You cannot use socket pooling if you run an IIS 5.0 server in a secure environment that requires you to limit the IP addresses that IIS 5.0 services listen on. Socket pooling can cause problems if the IIS 5.0 server is connected to multiple networks.

For example, you want to use Internet Security and Acceleration (ISA) Server 2000 to publish an internal SMTP server, but you also want IIS 5.0 SMTP Service to listen on the internal interface of the ISA Server-based computer. To publish the internal SMTP server:
Disable socket pooling for SMTP Service on the ISA Server-based computer.
Unbind the service from the external address of the ISA Server-based computer.
back to the top
The information in this article applies to:
Microsoft Windows 2000 Server
Microsoft Internet Information Services 5.0

woodsonlin

根据atong999888版主的建议，在2000上执行的mdutil的设置后，IIS的SMTP总算可以和Imail的SMTP同时运行了， 解决了我一个难题，不然我都准备更新服务器的操作系统了，影响很大啊。
再次感谢atong999888版主和钉子大大！！！

钉子

能把系统升级最好。